http://www.murata.com/ data sheet ! note: 1. this datasheet is downloaded from the website of murata manufacturing co., ltd. therefore, it?s specifications are subject t o change or our products in it may be discontinued without advance notice. please check with our sales representatives or product engineers bef ore ordering. 2. this datasheet has only typical specifications because there is no space for detailed specifications. therefore, please appr ove our product specifications or transact the approval sheet for product specifications before ordering. 1 o this data sheet is applied for chip common mode choke coil used for general electronics equipment for your design. 2011.1.13 noise suppression products/emi suppression filters > common mode choke coil > film type (array) 0.45 0.05 0.2 0.1 0.4 0.1 (1) (2) (3) (4) (5) (6) (7) (8) 1.5 0.1 0.65 0.1 0.2 0.1 (in mm) 0.1 min. : electrode 1 10 100 1000 10000 1 10 100 1000 10000 frequency (mhz) impedance ( ? ) differential mode common mode dlp1ndn670hl4 dlp1ndn900hl4 dlp1ndn350hl4 dlp1ndn350hl4 dlp1ndn670hl4 dlp1ndn900hl4 (1) (5) (6) (7) (8) (2) (3) (4) no polarity. common mode choke coil film type (array) dlp1nd series (0502 size) dimensions impedance-frequency characteristics (main items) equivalent circuit packaging code packaging minimum quantity l 180mm embossed tape 5000 b bulk(bag) 500 rated value ( p : packaging code) part number common mode impedance (at 100mhz/20 c) rated current rated voltage insulation resistance (min.) withstand voltage dc resistance operating temperature range dlp1ndn350hl4 p 35ohm 20% 100ma 5vdc 100m ohm 12.5vdc 1.8ohm 25% -40 to +85 c dlp1ndn670hl4 p 67ohm 20% 80ma 5vdc 100m ohm 12.5vdc 2.9ohm 25% -40 to +85 c dlp1ndn900hl4 p 90ohm 20% 60ma 5vdc 100m ohm 12.5vdc 3.7ohm 25% -40 to +85 c number of circuit: 2 ! caution (rating) do not use products beyond the rated current and rated voltage as this may create excessive heat and deteriorate the insulation resistance. notice solderability of tin plating termination chip might be deteriorated when low temperature soldering profile where peak solder temperature is below the tin melting point is used. please confirm the solderability of tin plating termination chip before use. ! caution/notice
|